MIL-S-18141J
(e)
A cooling liquid temperature indicator (for liquid cooled engines).
(f)
An hour meter.
(g)
A fuel gage.
(h)
A 12-volt starting and electrical charging system.
(i)
A dry charged battery.
3.11.11 Battery box . A weatherproof box made of steel or plastic shall be
provided for the battery. Vents shall be provided in the box. The box shall be
equipped with battery restraints. The box shall be located so that the battery
will be easily accessible for servicing, routine maintenance, removal, and
replacement. All interior surfaces of the steel box shall be treated with acid-
resistant paint.
3.12 Lubric ation. Lubrication means shall be provided for all parts of the
equipment normally requiring lubrication. Where the use of high lubrication
pressure will damage grease seals or other parts, fittings with pressure release
shall be used.
3.13 Cleaning. treatment. and painting. Unless otherwise specified (see
6.2), surfaces normally painted in good commercial practice shall be cleaned,
treated, and painted as specified herein. When specified (see 6.2), the unit
shall be cleaned, treated, and painted in accordance with MIL-T-704, type A, or
FED-STD-595. In either case, color of the finish coat shall be as specified
(see 6.2). Surfaces to be painted shall be cleaned and dried to insure that
they are free from contaminants such as oil, grease, welding slag and spatter,
loose mill scale, water, dirt, corrosion product, or any other contaminating
substances. As soon as practicable after cleaning, and before any corrosion
product or other contamination can result, the surfaces shall be prepared or
treated to insure the adhesion of the coating system. The painting shall
consist of at least one coat of primer and one finish coat. The primer shall
be applied to a clean, dry surface as soon as practicable after cleaning and
treating. Painting shall be with manufacturer's current materials according to
manufacturer's current processes and the total dry film thickness shall be not
less than 2.5 roils over the entire surface. The paint shall be free from runs,
sags, orange peel, or other defects.
3.14 Ident ification of product. Equipment, assemblies, and parts shall
be marked for identification in accordance with MIL-STD-130.
Each end item or independent component
3.14.1 Shipping data plate.
assemblage thereof, shall have a shipping data a plate attached as near as
practicable to the nameplate. They shall be permanently and legibly marked with
the following information:
(a)
Length - inches.
(b)
Height - inches.
(c)
Width - inches.
(d)
Cube - cubic feet.
(e)
Gross vehicle weight - pounds.
(f)
Center of gravity - location, inches.
3.14.2 Stenciling. The gross weight and location of the center of gravity
on each end item shall be stenciled on each unit in a manner easily discernible
to personnel handling the equipment.
8
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business