MIL-S-28566C(YD)
complete with the accessories normally furnished with the sweeper, including at
least the following:
Fuel tank.
a,
Engine housing.
b.
Instrument panel.
c.
Lubricant oil pressure gage.
d.
e.
Cooling liquid temperature indicator.
f.
Tachometer.
hour meter.
g.
h.
Fuel quantity indicator.
i.
Battery charging indicator.
Governor.
j.
A 12-volt electric cranking system, complete with maintenance free
k.
battery(s) with total reserve capacity rating and total cold
cranking ratings at 0°F in accordance with SAE J537.
3.9.2.1 Air cleaner. A dry type engine intake air cleaner of adequate
capacity for the engine furnished shall be provided. Means shall be provided
to prevent snow from being blown into the air cleaner intake.
3.9.2.2 Fuel system. The fuel system shall be a commercial standard, with
the fuel tank having sufficient capacity for not less than 8 hours of
continuous operation at maximum engine revolutions per minute. The tank shall
be properly baffled to prevent surging. The tank shall be equipped with an
easily accessible filler neck and drain plug. The filler opening shall permit
easy filling from fuel cans or hose nozzle. An accessible fuel shutoff valve
shall be provided at the tank outlet, if the outlet is at bottom of tank.
3.9.2.3 Fuel and oil filters. Commercial standard fuel and oil filters
shall be provided as recommended by the engine manufacturer, for use under the
conditions as specified herein. The filters shall be readily accessible and
shall provide for easy removal and replacement.
3.9.2.4 Safety devices. The engine shall be equipped with safety devices
that will automatically shut off the engine under conditions of low
lubricating oil pressure; high engine coolant temperature; high hydraulic oil
temperature; and engine overspeed.
3.9.3 Wheels and tires. The sweeper shall be equipped with at least three
basic wheels (exclusive of broom casters), one front and two rear wheels, Of
the tricycle type. The front wheel assembly shall be attached to the tow bar
and swivel mounted and so positioned that debris from sweeping is not thrown
onto the wheel during sweeping operations. The three wheel and tire
assemblies shall be identical. Tires, rims, and loadings shall be in
accordance with TRA recommendations.
3.9.4 Tow bar. The tow bar shall be designed for towing by vehicles
having a pintle hook height between 30 and 48 inches above ground level. The
tow bar shall be equipped with a 3 inch inner diameter lunette ring. Safety
chains shall be provided for securing the tow bars to the towing vehicle.
Safety chains and the tow bar shall meet the requirements of DoT Federal Motor
Carrier Safety Regulations.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business